Oiling Under Top Cover And Face Cover - Toyota 9600 Instruction Book

•
B. Oiling Under Top Cover And Face
Cover
Open face cover and apply one drop of oil to
lubricating points indicated by arrows.
Be careful not to apply too much oil or it may stain
your material and cause some sewing difficulty.
After oiling, run machine for 1-2 minutes to allow
oil to penetrate to every part.
Remove top cover by loosening screws
and with large screwdriver.
@
When top cover is removed, hand wheel does
not turn by hand, and at this time machine does
not work even if press foot controller.
Apply sprindle oil to lubricating points as above.
Assembling lop cover
Set bobbin winder spindle at right position. While move the spindle to left, place top cover down. Check the
machine moving by turning handwheel towards you.
Tighten screws with large screwdriver.
@
\
-37-
•