僅 Light Bulb Position (Front); 僅 Light Bulb Position (Rear); 僅 Light Bulb Position (Side) - Kia Cerato 2022 Owner's Manual

Maintenance
NOTICE
僅 If the light bulb or lamp connector is
removed from an operating lamp acti-
vated by electricity, the fuse box's
electronic device may scan it as a
malfunction. Therefore, a lamp mal-
function history may be recorded in
Diagnostic Trouble Code (DTC) in the
fuse box.
僅 It is normal for an operating lamp may
blink temporarily. Since this occur-
rence is due stabilization function of
the vehicle's electronic control device,
if the lamp lights up normally after
temporary blinking, there is no prob-
lem in the vehicle.
However, if the lamp continues to
blink several times or turn off com-
pletely, there may be an error in the
vehicle's electronic control device. In
this case, have the vehicle checked by
a professional workshop immedi-
ately. Kia recommends to visit an
authorised Kia dealer/service partner.
NOTICE
After an accident or after the headlight
assembly is reinstalled, have the head-
light aiming adjusted by a professional
workshop. Kia recommends to visit an
authorised Kia dealer/service partner.
NOTICE
You can find moisture inside the lens of
lamps after a car wash or driving in the
rain. It is a natural event caused by the
temperature difference between the
inside and the outside of the lamp and
does not mean a problem with its func-
tions. The moisture inside the lamp
would disappear if you drive the vehicle
with the headlamp turned on, however,
8 80
the level at which the moisture is
removed may differ depending on the
size / location / condition of the lamp. If
the moisture continues to stay inside the
lamp, have the vehicle checked by a
professional workshop immediately. Kia
recommends to visit an authorised Kia
dealer/service partner.
Light bulb position (Front)
Head lamp - Type A
OBD071028L
Head lamp - Type B
OBD071302L
Light bulbs