Pre-Installation - Dometic CCF-T Installation Manual

PRE-INSTALLATION

WARNING! Carbon monoxide and/or vehicle safety . Failure to obey the following warnings could result in death or serious injury:

Park the vehicle in a well-ventilated area during the installation process.

Ensure the vehicle is in Park with the emergency brake engaged at all times during the installation process.

Remove ignition key from the ignition key cylinder.

Remove negative terminal from the battery.
This section describes the assessment and location preparations to install the refrigerator.
ASSESSING THE INSTALLATION LOCATION
1. Confirm your vehicle is the correct model, model year, and trim level to accept the refrigerator. See "Specifications" for more information. Only trim
packages with an integrated center floor console are eligible
2. Verify you have the correct parts and tools to perform the refrigerator installation. See "Tools and Materials" for more information.
PREPARING THE FRONT FAN LOCATION
3. Tape the front fan template to the inside, front wall of the console bin.
4. Using a pen, trace the center point opening from the template onto the
console bin wall.
5. Use the 3.5 in. (89 mm) hole saw drill bit to drill an opening for the front
fan.
6. Remove the template and any debris from the console and console bin
area.
INSTALLATION
NOTICE!

Avoid lifting the weight of the refrigerator unit by the plastic edges. Otherwise damage to the edges could occur.

Do not leave the refrigerator unit in an inverted position or run the compressor soon after having the refrigerator in an inverted position.
Otherwise damage to the compressor could occur.

Avoid pinching, crushing, or breaking the wires or power cord. Otherwise damage to the refrigerator unit could occur.
This section describes how to install and wire the fan and the refrigerator unit, and how to install the foam protection material.
Dometic CCF-T Ford Expedition 2022 Installation Manual/ 2022-03-03/ Page 6 of 15
2.4 in (60 mm)
6.2 in (158 mm)
2.6 n (67 mm)
3.5 in (89 mm) Hole Saw Drill Bit
3.5 in (89 mm) Hole