Dometic CCF-T Installation Manual

DOMETIC CCF-T INSTALLATION MANUAL
PRODUCT SUITABLE FOR: Ford
®
;
Equipment Included: 1 Refrigerator Unit, 1 Rubber Mat,
1 Top Closeout Tray,
1 Front-Fan with Housing, 1 Front Fan Template,
1 Right & 1 Left Foam Console Wall Spacer
6
Time required: 35 Minutes
STEP 1: Prepare for setup by testing refrigerator
• Start by removing all items from center console including the original
trim tray and console floor liner
• Place the CCF-T upright on a stable surface next to the console
• Locate the fan power plug below the USB port
• Insert the unit's 12 V DC power cord into the vehicles 12 V DC receptacle
• Turn the engine on, at that time you should see the unit's blue LED light
illuminated. If you do not, press the hold button for 1 second and release.
You will hear the condenser fan start
• Turn the vehicle engine off. Then turn the refrigerator off by pressing
the blue button.
• Unplug the CCFT and set away from the console
STEP 2: Prepare the installation area
• Tape the provided front fan template to the interior front wall
of the console (image on 6.3 in user guide)
• Trace the center point opening from the console onto the taped
console bin wall with a pen
• With a 3.5 inch (89 mm) hole saw drill bit, drill an opening for
the front fan in line with the template
• Remove template & any debris in the console and console bin area
STEP 3: Install the console
Install Fan
• Hold the front fan vertically from the exterior (do not stick fingers in fan)
• Insert fan into newly drilled hole in front of console – you will hear
it snap into place
• Tape the black fan wire to top front lid of console to protect it
from damage
F-150, 2015–2020 Ford Super Duty (F-250/350/450/550), 2017 and newer Ford
®
.
*
**
?
Recommended Tools: Drill with 3.5 inch Hole Saw Bit,
Phillips Screwdriver, Multimeter, Pen,
Car Vacuum, and Removable Tape
K
Recommended number of people: 1
Expedition, 2018 and newer
®