Changing The Position Of The Securing Bar - Siemens SIMATIC NET SCALANCE XCH-100 Equipment Manual

Installation and disassembly
4.7 Changing the position of the securing bar
4.7

Changing the position of the securing bar

Rail mounting position - wall mounting position
To change the securing bar from the rail mounting position to the wall mounting position
follow the steps below:
1. If necessary, loosen the knurled screw with your hand or a screwdriver.
2. Move the securing bar down as far as it will go.
3. Hold the securing bar in this position.
4. Tighten the knurled screw (torque 0.5 Nm).
5. Remove the pin.
Wall mounting position - rail mounting position
To move the securing bar from the wall mounting position to the rail mounting position,
loosen the knurled screw.
30
– Use the levering aid and level the securing bar down using a screwdriver into this position.
– Push the securing bar down using your hand.
– Hold the securing bar with the screwdriver.
– Use the gap on the rear of the device and fix the securing bar briefly with a pin.
The securing bar is fixed in the wall mounting position.
SCALANCE XCH-100/XCM-100
Equipment Manual, 11/2022, C79000-G8976-C662-01