Replacing Filters - Bryant 524J 07 Installation, Start-Up And Service Instructions Manual

Replacing Filters

Filters can be removed and installed from either side of the
unit. Install new filters in units that have one fan as follows:
1. Remove the side access panel (retain screws).
2. Remove the filter retainer clip (see Fig. 26).
3. Remove old filters by lifting and tilting them out of the filter
track. (See Fig. 14 and 27.)
4. Reverse the procedure to install new filters.
To install new filters in larger units that have 2 fans, follow the
preceding steps, but use the factory-supplied filter hook to
slide filters within reach for removal. The filter hook is shipped
inside the unit in the filter track.
EQUIPMENT DAMAGE HAZARD
Failure to follow this CAUTION can result in premature
wear and damage to equipment.
DO NOT OPERATE THE UNIT WITHOUT THE RE-
TURN AIR FILTERS IN PLACE.
Dirt and debris can collect on heat exchangers and coils
possibly resulting in a small fire. Dirt buildup on compo-
nents can cause excessive current used resulting in motor
failure.
© 2022 Carrier
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
CAUTION
Edition Date: 1-22
Fig. 26 — Remove Filter Retainer Clip
Fig. 27 — Filter Removal/Replacement
Printed in U.S.A.
FILTER
RETAINER
CLIP
Form No: II524J-7-16-02 Rev. A
Replaces:II524J-7-16-01