Adjustment Procedure - ViewSonic N2230w-2M Service Manual

5. Adjustment Procedure

5.1. ADJUSTMENT CONDITIONS AND PRECAUTIONS
1. Approximately 30 minutes should be allowed for warm up before proceeding.
2. Adjustments should be undertaken only on those necessary elements since most of them
have been carefully preset at the factory.
3. ESD protection is needed before adjustment.
5.2. MAIN ADJUSTMENTS
NO. FUNCTION DESIGNATION
1. EEPROM Initial Function Key
2. Adjust color temperature Function Key
5.3. ALIGNMENT PROCEDURES
Adjustment Conditions and Precautions:
(A). Power supply voltage:AC 110V± 10% 50 Hz ± 5%.
(B). Warm up time:
The display must be power ON for at least 30 minutes at full white pattern before
starting alignments.
This is especially critical in color temperature and white balance adjustments.
(C). Video : reference the front detail specifications.
1. Eeprom Initial:
Press " MENU "and "▲" and "POWER" key go to factory mode.
2. Adjust color temperature
A. Enter to the factory mode, Source select " D_Sub" figure 2, Use 640x480@60Hz the pattern is
" 5 block " figure 1,then move the cursor to the White Balance figure 3. Press "►" key. That will do
auto white balance.
B. After auto white balance, switch to the full white pattern then check the color temperature.
WARM x=0.335 ± 0.03
NORMAL x=0.313 ± 0.03
COOL x=0.283 ± 0.03
C. Enter to the factory mode, Source select " YPbPr ", Use NTSC Color Bar (FLUKE 54200 )
Figure 4, Set Color bar to 100 IRE then move the cursor to the White Balance figure 5. Press "►"
Key figure 6. That will do auto white balance. Finally change 16 gray scale must be claire in each
grays.
ViewSonic Corporation
y=0.350 ± 0.03
y=0.329 ± 0.03
y=0.298 ± 0.03
29
Confidential - Do Not Copy
N2230w-2M