Configuration Process - Honeywell OELD Operating Instructions Manual

OELD User Manual (3018M5000_1-3)

5.2 Configuration Process

Note: Configuration is done by using mobile device only. There is no local interface to configure
OELD.
To configure OELD, it should be connected to mobile device over Bluetooth Low Energy first. The
blue backlit of OELD will flash when a mobile device pairs with OELD so that an operator can easily
find out and identify the target OELD. When OELD is connected to mobile device successfully the
blue backlight will stay on in normal condition. If the sensor is in abnormal condition, appropriate
backlit of OELD will flash according to sensor status instead of indicating BLE connection.
1. Tab the OELD mobile app icon on the mobile device to execute the app
2. Log in the mobile app by entering appropriate user ID and password
3. Scan the BLE devices nearby
4. Select the target OELD in the scanned BLE device list
5. Find out and identify the OELD flashing blue backlit
6. If the identified OELD is correct one, confirm the connection
7. Mobile app will establish the connection with OELD then move to main status screen
For detailed connection procedure refer to section 6.2 BLE communication.
If OELD is connected to mobile device, a user can configure OELD via configure menu on the mobile
application. For more details on operation of mobile application, refer to 7 OELD Mobile App
After successful configuration, terminate the BLE connection from the OELD so that other mobile
device can communicate with the OELD.
Note: After configuration it is recommended to read back and check the configuration from OELD to
make sure that the intended configuration changes are applied correctly.
Caution: Only one BLE connection is allowed. Terminate the BLE connection when a configu-
ration activity is done
Revision 1, Issue 3