Saeco Xelsis SUPREMA Manual page 32

32
Problem
The machine seems to be
leaking.
I cannot activate the
AquaClean water filter
and the machine asks for
descaling.
The new water filter does
not fit.
Cause
The machine uses water to rinse
the internal circuit and brew
group. This water flows through
the internal system directly into
the drip tray. This is normal.
The drip tray is too full and has
overflowed which makes it look
like the machine is leaking.
The water tank is not fully
inserted, some water is leaking out
of the water tank and air is drawn
into the machine.
The brew group is dirty/clogged.
The machine is not placed on a
horizontal surface.
The filter has not been installed or
replaced in time after the screen
showed the AquaClean reminder.
This means your machine is
not completely free of limescale
anymore.
You are trying to install another
filter than the AquaClean water
filter.
The rubber ring on the AquaClean
water filter is not in place.
Solution
spout to collect rinsing water and reduce
the amount of water in the drip tray.
Make sure the water tank is in the correct
position: remove it and reinsert it into the
machine as far as possible.
Rinse the brew group.
Place the machine on a horizontal surface
so that the drip tray does not overflow and
the 'drip tray full' indicator works properly.
Descale your machine first and then install
the AquaClean water filter.
Only the AquaClean water filter fits into
the machine.
Place back the rubber ring on the
AquaClean water filter.
Empty the drip
tray every day
or as soon as
the 'drip tray full'
indicator pops up
through the drip
tray cover. Tip:
Place a cup under
the dispensing
Empty the drip
tray every day
or as soon as
the 'drip tray full'
indicator pops up
through the drip
tray cover.