Table of Contents
Advertisement
4 Measures for preparation
After receiving the shipment, proceed as
follows:
1. Check the scope of delivery. Compare
the shipment received with the delivery
note.
2. Check the shipment for transportation
damage. Report any transportation dam-
age.
4.1 Unpacking
Note
Do not remove the packaging if the limit
switch is to be transported to another loca-
tion or kept in storage.
Before mounting the limit switch, proceed as
follows:
1. Remove the packaging from the limit
switch.
2. Dispose of the packaging in accordance
with the valid regulations.
4.2 Transporting
Î Pack the limit switch properly to comply
with terms of transportation.
Transport instructions
− Protect the limit switch against external
influences (e.g. impact).
− Protect the limit switch against moisture
and dirt.
− Observe transport temperature depend-
ing on the permissible ambient tempera-
ture (see technical data in section 3.5).
EB 4747 EN
Measures for preparation
4.3 Storage
NOTICE
!
Risk of damage to the limit switch due to
improper storage.
Observe the storage instructions. Contact
SAMSON, if need be.
Storage instructions
− Protect the limit switch against external
influences (e.g. impact, shocks, vibra-
tion).
− Do not damage the corrosion protection
(coating).
− Protect the limit switch against moisture
and dirt. In damp spaces, prevent con-
densation. If necessary, use a drying
agent or heating.
− Observe storage temperature depending
on the permissible ambient temperature
(see technical data in section 3.5).
5 Mounting
The limit switch is suitable for the following
types of attachment:
− Direct attachment to SAMSON
Type 3277 Actuator
− Attachment to actuators according to
IEC 60534-6 (NAMUR rib)
− Attachment to Type 3510 Micro-flow
Valve
− Attachment according to VDI/VDE 3845
to rotary actuators
21
Advertisement
Table of Contents
