ResMed AirMini User Manual page 23

Problem/possible cause
The light above the Start/Stop button is flashing green
An error has occurred on the machine.
I am experiencing dryness (dry or blocked nose)
Mask may be fitted incorrectly
I am using a waterless humidifier and I am getting uncomfortable droplets of
water on my nose, mask or air tubing
Humidity level is too high
Solution
Unplug your machine. Wait a few seconds
and then plug it back in.
If the problem persists, contact your care
provider. Do not open the machine.
Adjust and refit your mask to improve seal.
Check that there is no air leaking from the
mask.
If mask seal is good, try the HumidX Plus.
If using the HumidX or HumidX F20:
Remove the humidifier and try therapy
without humidification.
If using the HumidX Plus: Try the HumidX
instead. This will help to reduce the water
droplets.
If you are still experiencing problems,
contact your care provider.
Note: You may need to use a waterless
humidifier when ambient humidity
conditions change.
English 21