Media Output Locations - Xerox B210DNI User Manual

Media Output Locations

The device has two output locations:
• Output tray, face down, up to a maximum of 150 sheets
of 20 lb (80 g/m²) paper.
The output tray collects printed paper face down, in the
order in which the sheets were printed. The output tray
should be used for most jobs. When the output tray is
full, a message displays on the control panel.
To use the output tray, make sure that the rear cover is
closed.
Notes:
• If paper coming out of the output tray has
problems, such as excessive curl, try printing to
the rear cover.
• To reduce paper jams, do not open or close the rear cover while the printer is printing.
• Rear cover, face up, one sheet at a time.
The device sends output to the output tray by default. If
using special media, such as envelopes, or excessive curl
or creases appear, the rear cover should be used for the
output. Open the rear cover and keep it open while
printing one sheet at a time.
Note: The rear cover output can only be used for simplex
jobs. Duplex printing with the rear door open will cause
paper jams.
CAUTION:
The fuser area inside the rear cover of your
device becomes very hot when in use. Take care when
you access this area.
Parts of the Printer
Xerox B210 Printer
®
User Guide
25