Table of Contents
Advertisement
Available languages
Available languages
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
INTRODUCTION
The start of the appliance does not occur or it
stops during operation.
First try to find a solution to the problem (refer to
the table). If not, contact the Authorised Service
Centre.
With some problems, the acoustic signals operate.
The red indicator of the button Start/Pauze Départ/
Pause flashes and one of the phase indicators
comes on, to show an alarm code:
POSSIBLE FAILURES
Problem
The programme does not
start.
The appliance does not fill
with water properly.
The appliance does not
drain the water.
The spin phase does not
operate or the washing cy-
cle lasts longer than usual-
ly.
•
•
•
•
•
Make sure that the mains plug is connected to the mains socket.
•
Make sure that the appliance door is closed.
•
Make sure that there is not a damaged fuse in the fuse box.
•
Make sure that the Start/Pause has been pressed.
•
If the delay start is set, cancel the setting or wait for the end of
countdown.
•
Deactivate the Child Lock function if it is on (if available).
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not too low. For
this information, contact your local water authority.
•
Make sure that the water tap is not clogged.
•
Make sure that the filter of the inlet hose and the filter of the valve
are not clogged. Refer to "Care and cleaning".
•
Make sure that the inlet hose has no kinks or bends.
•
Make sure that the connection of the water inlet hose is correct.
•
Make sure that the drain hose is in the correct position. The hose
may be too low.
•
Make sure that the sink spigot is not clogged.
•
Make sure that the drain hose has no kinks or bends.
•
Make sure that the connection of the drain hose is correct.
•
Set the drain programme if you set a programme without drain
phase.
•
Set the drain programme if you set an option which ends with water
in the drum.
•
If above mentioned solutions do not help, contact the Authorised
Service Centre (as the filter of the drain pump may be clogged).
•
Set the spin programme.
•
Adjust manually the items in the tub and start the spin phase again.
This problem may be caused by balance problems.
•
If above mentioned solutions do not help, contact the Authorised
Service Centre (as the filter of the drain pump may be clogged).
- The appliance does not fill with water
properly.
- The appliance does not drain the water.
- The appliance door is open or not closed
correctly. Please check the door!
The indicator of button Start/Pauze Départ/
Pause flashes in red 11 times and 1 (or 2 or 3)
time(s) in green: the mains supply is unstable.
Wait until the mains supply is stable and the
appliance automatically starts operating.
WARNING! Deactivate the appliance
before you do the checks.
Possible solution
15
Advertisement
Table of Contents
