Emerson Rosemount 248 Quick Start Manual page 6

Quick Start Guide
2.2 Verify transmitter configuration
To verify operation using a Field Communicator, refer to the Rosemount 248
Reference Manual
2.3 Install PC programmer kit (HART
Procedure
1. Install all necessary software for PC configuration:
Note
For USB modem: Upon first use, configure appropriate COM ports
within the Rosemount 248 PC software by selecting Port Settings
from the Communicate menu. The USB modem driver emulates a
COM port and will add to available port selections in the software's
drop-down box. Otherwise software defaults to first available COM
port, which may not be correct.
2. Set up configuration system hardware:
2.3.1 Spares kit and re-order numbers
Table 2-1: Programming Kit Spare Part Numbers
Product description
Programming software (CD)
Rosemount 248 Programmer Kit - USB
Rosemount 248 Programmer Kit - Serial
For more information, refer to the Rosemount 248
6
for more detailed description.
a) Install the Rosemount 248C software
1. Place the CD-Rom in the drive.
2. Run setup.exe from Windows
b) Install the MACTek
beginning bench configuration with the Rosemount 248 PC
Programming system.
a) Hook up the transmitter and load resistor (250-1100 ohms)
wired in series with the power supply.
The device will need an external power supply of 12-42.4 Vdc
for configuration.
b) Attach the HART modem in parallel with the load resistor and
connect it to the PC.
®
5 only)
®
HART modem drivers completely before
Part number
00248-1603-0002
00248-1603-0003
00248-1603-0004
Reference
February 2021
™
7, 8, 10, or XP.
Manual.