Troubleshooting - Hilti TE 700-AVR Original Operating Instructions

• Check electric tools or appliances for damage after long periods of
transport or storage.
9

Troubleshooting

If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
9.1 Troubleshooting
Trouble or fault
The breaker doesn't
start.
No hammering ac-
tion.
12 English
Possible cause
Electronics initialization
in progress (takes up to
4 seconds after plugging
in).
The electronic restart
interlock is activated
after an interruption in
the electric supply.
Interruption in the elec-
tric supply.
The generator is in sleep
mode.
The tool is faulty or ser-
vicing is due.
The power tool is too
cold.
Action to be taken
▶ Switch the power tool
off and then on again.
▶ Switch the power tool
off and then on again.
▶ Plug in another electric
tool or appliance
and check whether it
works.
▶ Apply a load to
the generator by
connecting a second
power consumer (e.g.
worklight). Switch the
tool off and then on
again.
▶ Have the product
repaired only by Hilti
Service.
▶ Bring the tip of the
accessory tool into
contact with the
working surface,
switch the power
tool on and allow it
to run. If necessary,
repeat the procedure
until the hammering
mechanism begins to
operate.
428076
*428076*