Setup Wizard; Source Setup; Language Select; Speaker Connection - Marantz SR5006 Getting Started Manual

ENGLISH DEUTSCH

Setup Wizard

When preparations are complete, start the Setup Wizard.
Use the Setup Wizard to perform connections and settings as shown in the following steps. Perform the operations as described in the
instructions on the screen. You can skip or cancel at each section if necessary.
1

Language Select

Set the language for the instructions on
the television screen.
These settings can be changed in the following menu even after setting the Setup Wizard
(vm page 106 "Language").
2

Speaker Connection

Connect the speakers for surround sound.
NOTE
Connections for speakers other than 7.1 channel or 5.1
channel speakers cannot be set using the Setup Wizard.
Select "Others", and then select "Skip" in "2. Speaker Connection" to proceed to "3. Speaker
Calibration". (For details on the setting method, see m page 58 "Speaker installation/connection
(Advanced connection)".)
3

Speaker Calibration

Configure the settings for your speakers,
and for the optimum surround sound for
your room.
These settings can be changed in the following menu even after setting the Setup Wizard
(vm page 19 "Set up speakers (Audyssey ® Auto Setup)").
4
FRANÇAIS ITALIANO ESPAÑOL
Language Select
Please select the
English
language for the on
Español
screen menu.
Speaker Connection
Please select the
speaker configuration
to be used.
5.1ch
7.1ch
Others
7.1ch adds 2 more
speakers to 5.1ch, for
enhanced surround.
Speaker Calibration
Detect & Measure (Main)
Please connect
microphone.
Measure
NEDERLANDS SVENSKA
4

Source Setup

Set the connecting terminals for each
device to be set, and connect to the
terminals.
These settings can be changed in the following menu even after setting the Setup Wizard
(vm page 109 "Input Assign").
5

Network Setup

Configure to playback audio files saved
onto a computer or Internet radio.
These settings can be changed in the following menu even after setting the Setup Wizard
(vm page 99 "Network Setup").
This completes the Setup Wizard.
MultEQ XT
Source Setup
Please select device.
[1/2]
BD
DVD
VCR
SAT
GAME
AUX
Network Setup
Please connect LAN cable to ETHERNET port on
rear panel of receiver, and other side of
cable to network router.
When connection is complete, press [ENTER]
to continue.