Install Processor Heatsink(S); Install Memory Modules - Intel R1000GL Series Quick Installation User's Manual

General Installation Process
6

Install Processor Heatsink(s)

CAUTION: The heatsink has thermal interface
material (TIM) on the underside of it. Use caution so
that you do not damage the thermal interface material.
Use gloves to avoid sharp edges.
A
Remove the protective film on the TIM if present.
B
Align heatsink fins to the front and back of
the chassis for correct airflow.
Airflow goes from front-to-back of chassis.
Each heatsink has four captive fasteners and
should be tightened in a diagonal manner using
the following procedure:
Using a #2 Phillips* screwdriver,
C
start with screw 1 and engage screw
threads by giving it two rotations
and stop. (Do not fully tighten.)
D
Proceed to screw 2 and engage screw
threads by giving it two rotations and
stop. Similarly, engage screws 3 and 4.
E
Repeat steps C and D by giving each
screw two rotations each time until
each screw is lightly tightened up to
a maximum of 8 inch-lbs torque.
Install Memory Modules ... Continued
Memory Configurations and Population Order:
For best performance, a minimum of four DIMMs per CPU is recommended, populated in the blue slot of each memory channel.
In a single-processor configuration, always populate A1 DIMM first.
In a dual-processor configuration, always populate A1 DIMM first for CPU1 and E1 DIMM first for CPU2.
Note: For additional memory configurations, see the Service Guide on the Intel
Server System, or go to: http://www.intel.com/support.
Memory sizing and configuration is supported only for qualified DIMMs approved by Intel. For a list of supported memory, go to:
http://serverconfigurator.intel.com.
CAUTION:
Do not
over-tighten
fasteners.
B
3
D
2
E
4
TIM
A
NOTE: Heatsink styles may vary.
Intel® Server Board S2600GZ
CPU1 Socket
4
7

Install Memory Modules

DDR3 DIMM Memory Identification:
CAUTION: Observe normal ESD (ElectroStatic
Discharge) procedures to avoid possible damage to
system components.
DIMM notch and socket bump must align as shown below.
C
1
DDR3
CPU2 Socket
Server Deployment & Management DVD that accompanied your Intel
®
Other
Memory
®