Makita LS1013 Instruction Manual page 15

1
1. Support
2. Turn base
1
1. Sub-fence
1
1. Sub-fence
1. Sub-fence R
2. Screws
CAUTION:
• When cutting long workpieces, use supports that are as
001549
high as the top surface level of the turn base. Do not rely
2
solely on the vertical vise and/or horizontal vise to
secure the workpiece.
Thin material tends to sag. Support workpiece over its
entire length to avoid blade pinch and possible
KICKBACK.
Sub-fence
001545
This tool is equipped with the sub-fence. It should be posi-
tioned as shown in the figure.
001546
CAUTION:
• When performing left bevel cuts, flip the fence over to the
left position as shown in the figure. Otherwise, it will
contact the blade or a part of the tool, causing possible
serious injury to the operator.
Sub-fence R (optional accessory)
001547
1
The sub-fence R can be installed on the right side of the
guide fence. Insert the rods of the sub-fence R into the holes
in the guide fence. Tighten the screws which come with the
sub-fence R to secure the sub-fence R.
CAUTION:
2
• When performing right bevel cuts, never use the sub-
fence R. It will contact the blade or a part of the tool,
causing possible serious injury to the operator.
15