Makita LS1013 Instruction Manual page 16

Slide compound saw equipped with electric blade brake 255 mm (10”)
Hide thumbs Also See for LS1013:
Table of Contents

Advertisement

2
1
3
1. Vise arm
2. Vise rod
3. Screw
4. Clamp screw
5. Guide fence
1
2
3
1. Vise plate
2. Vise nut
3. Vise knob
16
Vertical vise
001548
4
The vertical vise can be installed in two positions on either
the left or right side of the guide fence or the base. Insert the
vise rod into the hole in the guide fence or the base and
tighten the screw to secure the vise rod.
Position the vise arm according to the thickness and shape
5
of the workpiece and secure the vise arm by tightening the
screw. If the screw to secure the vise arm contacts the guide
fence, install the screw on the opposite side of vise arm.
Make sure that no part of the tool contacts the vise when
lowering the handle fully and pulling or pushing the carriage
all the way. If some part contacts the vise, re-position the vise
arm.
Press the workpiece flat against the guide fence and the turn
base. Position the workpiece at the desired cutting position
and secure it firmly by tightening the vise knob.
CAUTION:
The workpiece must be secured firmly against the turn
base and guide fence with the vise during all operations.
Horizontal vise (optional accessory)
001550
The horizontal vise can be installed in two positions on either
the left or right side of the base. When performing 15° or
greater miter cuts, install the horizontal vise on the side
opposite the direction in which the turn base is to be turned.
By flipping the vise nut to the left, the vise is released, and
rapidly moves in and out. To grip the workpiece, push the
vise knob forward until the vise plate contacts the workpiece
and flip the vise nut to the right. Then turn the vise knob
clockwise to secure the workpiece.
The maximum width of workpiece which can be secured by
the horizontal vise is 200 mm (7 - 7/8").
When installing the horizontal vise on the right side of the
base, also use the sub-fence R to secure the workpiece
more firmly. Refer to the "Sub-fence R" section described on
previously for installing the sub-fence R.
CAUTION:
Always rotate the vise nut to the right fully when securing
the workpiece. Failure to do so may result in insufficient
securing of the workpiece. This could cause the workpiece
to be thrown, cause damage to the blade or cause the loss
of control, which can result in PERSONAL INJURY.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents