Makita LS1013 Instruction Manual page 24

1
3
Fig. B
1. Crown molding stopper L
2. Crown molding stopper R
3. Turn base
1
3
1. Crown molding stopper L
2. Crown molding stopper R
3. Turn base
2
1 3
1. Guide fence
2. Crown molding
3. Crown molding stopper
4. Screw
24
Crown molding stoppers (optional accessories) allow
001558
2
easier cuts of crown molding without tilting the saw
blade. Install them on the turn base as shown in the fig-
ures.
Fig. B: At right 45° miter angle
Fig. C: At left 45° miter angle
001559
2
Fig. C
Position crown molding with its WALL CONTACT EDGE
001560
against the guide fence and its CEILING CONTACT
EDGE against the crown molding stoppers as shown in
4
the figure. Adjust the crown molding stoppers according
to the size of the crown molding. Tighten the screws to
secure the crown molding stoppers. Refer to the table
(C) for the miter angle. Use the sub-fence R to secure
the crown molding more firmly.
For inside
corner
For outside
corner
Table (C)
Position
Miter angle
in Fig. A
(1) Right 45˚
(2)
Left 45˚
(3)
(4) Right 45˚
Finished piece
Save the right side of blade
Save the left side of blade
Save the right side of blade
Save the left side of blade