Installation; Programming - Prince Castle Merlin II Operating Instructions Manual

INSTALLATION

1. After you have removed the timer from the carton,
inspect the unit for signs of damage. If there is
damage to the unit:
Notify carrier within 24 hours after delivery.
!
Save carton and packing materials for inspection
!
purposes.
Contact your local dealer or, if purchased di-
!
rectly, the Prince Castle Customer Sales Depart-
ment at 1-800-722-7853 to arrange for a replace-
ment to be sent.
2. Verify that all parts have been received. Mounting
Brackets and hardware provided.
3. To mount the timer, place mounting brackets in de-
sired location. Scribe location of mounting holes,
center punch, and drill holes. Attach timer to mount-
ing brackets placing star washer between bracket and
timer.
DISPLAYS AND INDICATORS
Shows the time for the selected channel
TIME
number.
Display
Indicates the time value is in Hours and
H:M
Minutes.
Indicates that the time value is in
M:S
Minutes and Seconds.
Located above each channel timer
LED
button, these lights change color
Indicators
depending on the stage of the count-
down. RED = Stage 1, GREEN =
Stage 2 YELLOW = Stage 3.
CONTROLS
Channel
Activates countdown sequence in the
(Button)
run mode.
In the program mode, it increases time
values for each channel . In the Run
Mode, it is used in conjunction with logo
SCAN/UP
button to increase the volume.
ARROW
In the program mode, it decreases time
values for each channel . In the run
mode, it is used in conjunction with logo
SCAN/DOWN
button to decrease the volume.
ARROW
PRINCE Activates Program Mode and used to
CASTLE adjust the alarm sound level.
Logo
The timer currently supports 3 program stages or
functions. Each program stage is independently
programmed. The stages run in succession begin-
ning with stage #1 and ending with stage #3.
Below Are The Pre-Set Stages Per Donato's speci-
fications. These are pre-programmed times for
channels 1-7. Channel 8 is a special Accelerate
Mode.Note: All times are in H:M Hours & Minutes.
Stage
RED
GREEN
YELLOW

PROGRAMMING

1.Press and hold the PRINCE CASTLE logo for six
seconds. The TIME displays will change from
"----" to "Prog" and a beep will sound.
P r o g
P r o g
P r o g
P r o g
P r o g
P r o g
IMPORTANT: If a channel is not pressed within 30
seconds the display will change back to
"- - : - -" and the timer will automatically
go back to the run mode.
NOTE: While all displays are showing "Prog", press-
ing the UP or DOWN ARROW Button will
increase or decrease, respectively, the display
intensity level.
2. Press the channel button for the particular timer
channel you wish to program. The time window
for the selected channel will show the current
time for Red stage and the LED indicator will be
red. This is the red stage program mode.
2
Time
36:00
42:00
14:00