Installation; Programming - Prince Castle Merlin II 740-T Series Operating Instructions Manual

INSTALLATION

1. After you have removed the timer from the carton,
inspect the unit for signs of damage. If there is
damage to the unit:
Notify carrier within 24 hours after delivery.
!
Save carton and packing materials for inspection
!
purposes.
Contact your local Prince Castle dealer or, if
!
purchased directly, the Prince Castle Customer
Sales Department at 1-630-462-8800 to arrange
for a replacement to be sent.
2. Verify that all parts have been received. Mounting
brackets and hardware are provided.
3. To mount the timer, place mounting brackets in de-
sired location. Scribe location of mounting holes,
center punch, and drill holes. Attach timer to mount-
ing brackets placing star washer between bracket and
timer.
DISPLAYS AND INDICATORS
TIME
Shows the time for the selected channel
Display
number.
CHANNEL
Shows the channel number selected
Display
and in use. (The 740-T2 model does
not have this display.)
H:M
Indicates the time value is in Hours and
Minutes.
M:S
Indicates that the time value is in
Minutes and Seconds.
LED
Indicators Located above each channel timer
button, these lights change color
depending on the stage of the count-
down. Green = first 70% of countdown,
Yellow = next 20% countdown,
Red = last 10% of countdown.
CONTROLS
The 740-T2 has 2 channels, the 740-T4
has 4 channels, the 740-T8 has 8
Channel
channels and the 740-T12 has 12
(Timer)
channels.
Printed in USA 3/06 © 2006
SCAN/UP In the program mode, it increases time
ARROW values for each channel . In the Run
Mode, it is used in conjunction with logo
button to increase the volume.
SCAN/DOWN
In the program mode, it decreases time
ARROW
values for each channel . In the run
mode, it is used in conjunction with logo
button to decrease the volume.
PRINCE
Activates Program Mode and used to
CASTLE
adjust the alarm sound level.
Logo

PROGRAMMING

1. To program, press and hold the PRINCE CASTLE
logo for six seconds. The TIME display changes
from ---- to Prog, and a beep will sound.
See figure 1.
figure 1
2. Select and press the timer channel to be pro-
grammed. The LED indicator for the selected
button will turn yellow and a beep will sound. The
selected channel number will be displayed in the
CHANNEL display, the current programmed time
for that channel will be displayed in the TIME
display, and the time value will indicate either H:M
OR M:S. See figure 2.
figure 2
3. To change the program time for the selected
channel, use the SCAN/UP Arrow or the SCAN/
DOWN Arrow button.
2
P r o g
1
8:00
740-517revB