Table of Contents
Advertisement
2.3
Labeling Function Keys
Labeling when
When the unit is supplied, the operator panel function keys are labeled as fol-
supplied
lows:
A set of unlabeled strips is included with the OP. This means that you can pre-
pare labels for the OP specifically for your system.
Replacing labeling
To replace the labeling strips proceed as follows:
strips
1. Place the unit face down.
Caution
!
Make sure the OP is disconnected from the power supply.
2. With reference to Figure 2-4, release the rivets
Figure 2-4
3. Remove the covers.
OP37/Pro Equipment Manual
Release 7/98
F1 to F20 and
K1 to K16.
Release rivets
Phaysical Installation
1
.
2-5
Advertisement
Table of Contents
