Installation Hardware; Mounting Space; Parts List - Magic Chef KOT-131UB Installation Manual

Installation Hardware

3
7
The following is a list of parts you may
need for installing your Over-the-Range
microwave oven. You will find them
packaged inside the microwave cooking
cavity. Remove all parts from the oven
cavity and compare them with the parts

Mounting Space

30" more than from
cooking surface
66" or more
from the
floor to the
top of the
microwave
oven
5
1
2
4
list and illustration to be sure that none
are missing. Use this time to become
familiar with each piece.
OTR
30"
6
8
0
2

Parts List

1. Lag screws 1/4" x 2" ( 3 EA )
2. Toggle Bolts 3" ( 3 EA )
3. Spring Loaded Toggle Nuts ( 3 EA )
4. Cabinet Mounting Bolts 1/4" x 3-
1/8" ( 3 EA ), 1/4" x 2" (3 EA)
5. Washers 3/4" ( 3 EA )
6. Gromment
7. Damper
8. Foam Tape ( 2 EA )
9. Top Cabinet Template
10. Wall Template
Tools
The following tools may be needed for
installation of your microwave oven.
Phillips screwdrivers, Electric Drill
Motor, 1/2" & 5/8" Wood Bits & 3/16"
Drill Bit, Saw to cut exhaust opening,
(if needed) or Jig Saw, Tin Snips (if
needed), Pencil, Tape Measure, Paper
Tape & Duct Tape.
Your Over-the-Range microwave oven
requires mounting space on a wall as
shown.
1. A minimum of 30" between wall
hung side cabinets is required for
installation. Make sure the bottom
edge of the top cabinet is at least 66"
from the floor and 30" from the
cooking surface.
2. For easier access to the hood lamp,
the bottom of the microwave oven
should be at least 2" above the range
backsplash.
3. If you are going to vent your
microwave oven to the outside, see
exhaust duct preparation.
4. Designed to be installed in 30" wide
cabinet opening.