Table of Contents
Advertisement
9.3.4. Oil spray nozzle
•
Assemble the oil spray nozzle.
•
Tighten the fixing bolts.
9.3.5. Tappet
Coat the tappet wholly with clean oil and
push in the tappet hole of the cylinder
block.
9.3.6. Crankshaft
•
Put the wear ring into the heater to
heat it up to 150 ~ 200
it over the crankshaft by means of a
jig.
•
Assemble the main bearing to the
cylinder block and coat it with engine
oil. Then assemble the bearing that
has a hole to the cylinder block side
and one that has no hole to the
bearing cap and be careful not to
change.
˚
C level, push
- 95 -
Wear ring
EA6M2009
EFM2060I
Advertisement
Table of Contents
