Table of Contents
Advertisement
CARE AND MAINTENANCE
BUCKLE OPERATION
To ensure the buckle remains operational, the inside of the buckle must be kept free of liquids,
sand, dirt, fluff, food or similar substances. If the buckle is not operating or you do not hear a
strong audible click when the second tongue is inserted then the buckle needs to be washed
or replaced. The buckle is fully engaged when both tongues are inserted and a 'click' is
heard. Contact Customer Service for assistance.
CLEAN HARNESS BUCKLE:
If sticky liquids such as baby formula, fruit juice, etc. get inside your harness buckle, it may
become sluggish. An indication of a sluggish harness buckle is that you cannot hear a click
when engaging the second harness tongue. To restore the harness buckle to good working
order it needs to be cleaned as follows:
Cover
A
B
Click
C
72
Instructions for Installation & Use
A. To remove the harness buckle from the
Body
3-bar slide
B. Place the harness buckle under warm (max.
C. If you still cannot hear a strong audible click
D. Refit the harness buckle to the restraint
restraint: From the underside of the child seat
pull out each metal 3-bar slides. Turn each
metal 3-bar slide on its side and push back
through the slots, aligning the slide to pass
through all slots in hardware.
40 degrees celsius) running water as shown
below. Let the water run through the mouth of
the buckle for five minutes. Check the harness
buckle is clean by engaging the harness
tongues and buckle several times until you hear
a click.
then repeat the cleaning process several times.
ensuring the red button facing outwards and
the 3-bar slide is fed through the same slots.
If the harness buckle cannot be returned to its
original working condition then contact Britax
Customer Service for assistance.
®
Advertisement
Table of Contents
