Table of Contents
Advertisement
5. Installation
3m
• Ensure the mains supply is switched off and the circuit supply fuses
are removed or the circuit breaker turned off.
Side View
• An isolating switch should be installed to enable the power to be switched
ON and OFF for maintenance purposes.
• Mark the position of the 65mm diameter locating hole centre, taking care
3m
to avoid ceiling joists and other obstructions within the 65mm diameter.
Side View
• Drill a pilot hole to take the centre shaft of the hole cutter.
Up to 3m Presence Detection
• Use the hole cutter to cut the required hole.
3m
Up to 10m Motion Detection
• Pass the 230V 50Hz mains supply and load cables through the hole
and prepare for termination.
Top View
Up to 3m Presence Detection
• Terminate the cables into the terminal block ensuring correct polarity is observed
and that all bare conductors are sleeved (See section 6. Connection Diagram).
Up to 10m Motion Detection
• When wiring is complete, fit the cable clamp wiring cover to the sensor unit
Top View
with the 2 screws provided (See diagram "E").
3
• The adjustment knobs located beneath the sensor head (see diagram "C")
are factory set to "Walk Test Mode". Double check they are set as follows;
TIME – Fully anti-clockwise (Test mode).
DUSK – Fully clockwise.
Note: Make sure the Lux and Time controls are located at the bottom of the product.
• Fit the sensor to the wall box and secure it with the two fixing screws provided.
Less
sensitive
Up to 3m Presence Detection
Up to 10m Motion Detection
Top View
Side View
3m
360
Up to 3m Presence Detection
Up to 10m Motion Detection
360
Top View
Time On
Time On
settin g
More
sensitive
Switched
Load
OUT
L
ocating
springs
More
sensitive
360
Less
sensitive
Less
sensitive
Lux
360
Lux
Dusk/Daw n
settin g
Levering area
230V AC 50Hz
Mains Supply
IN
L1
N
N
L
Less
sensitive
More
sensitive
Time On
Time On
settin g
Switched
Load
OUT
L1
Locating springs fitted p
L
ocating
springs
pulled
More
sens
Less
sensiti
Lev
2
M
I
N
N
L
Advertisement
Table of Contents
