Reattaching The Wiring Card - Cisco 3200 Series Hardware Upgrade Manual

Chapter 3 Replacing Cards in the Cisco ISR 3270 Rugged Enclosure

Reattaching the Wiring Card

Step 1
Step 2
Step 3
Step 4
OL-15983-01
Get user manuals: See SafeManuals.com
To reattach the wiring card to the card stack, follow these steps:
Attach the wiring card to the front of the card stack by aligning ports and firmly pressing the card into
the stack.
If WMICs are present, make sure that the WMIC mounting boss is within 0.01 inch of the wiring card.
Using a Phillips screwdriver, tighten the wiring card screws using 5.5 to 5.7 in-lb torque, as shown in
Figure 3-4.
In a 0-WMIC configuration, screw number 2 is not used.
Note
Connect the cables to the wiring card, as shown in
For a 0-WMIC configuration, connect the cables to the wiring card as shown in
Figure 3-11 0-WMIC Configuration
1
1 Connect the FESMIC 10-pin FE1X cable to
port J14 on the wiring card.
3
Connect the FESMIC 10-pin FE2X cable to
port J4 on the wiring card.
For a 1-WMIC configuration, connect the cables to the wiring card as shown in
Figure 3-11.
2
3
4
2 Connect the FESMIC 10-pin FE3X cable to
port J16 on the I/O card.
4
Thread the FE extender cable under the card
stack to the antenna end cap side.
Cisco 3200 Series Router Hardware Upgrade Guide
Card Replacement Process
Figure 3-11.
Figure 3-12.
3-11