Chapter 3
Replacing Cards in the Cisco ISR 3270 Rugged Enclosure
Replacing or Adding a New Card
Inserting the Card Stack into the Enclosure
Step 1
Step 2
Step 3
Step 4
OL-15983-01
Get user manuals:
See SafeManuals.com
To replace or add new cards, follow the steps in the
page
2-23.
To insert the card stack into the rugged enclosure, follow these steps:
Make sure that the LED cable is connected to the back of the Fast Ethernet Switch Mobile Interface Card
(FESMIC) and the serial console cable is connected to the back of the SMIC card. See
Figure 3-6
LED and Serial Console Cables
1
1
LED cable
Route the serial connector and (FESMIC) LED ribbon cables over the top of the stack.
Align each cards' Wedge Loks so that the angles on the Wedge Loks match the angle of the Wedge Lok
rail.
Figure 2-9
shows proper Wedge Lok alignment.
Place the extrusion vertically on a sturdy, flat surface with the antenna end cap side facing up.
"Replacing or Adding a New Card" section on
2
2
Serial console cable
Cisco 3200 Series Router Hardware Upgrade Guide
Card Replacement Process
Figure
3-6.
3-7