Cobra microTALK PR 1050 WX Operating Instructions Manual page 7

O P E R AT I O N
Using the Scan Function
(continued):
To scan privacy codes:
1. While in Standby mode, press the
CHANNEL SELECT button up or down to
choose the main channel you wish to scan.
2. Press the MODE
MODE
button until the
button
Scan icon and the
privacy code
number flashes.
3. Push the CHANNEL SELECT button up or
down and the unit will begin scanning
privacy codes within the main channel
you selected.
4. The radio will continue to scan privacy
codes and stop if an incoming transmission
is detected. The unit will remain on that
code for 10 seconds. During that time
you can:
a) Press and hold the TALK button and talk.
The radio will remain on that channel and
privacy code, then return to Standby mode.
b) Push the CHANNEL SELECT button up
or down to resume scanning privacy codes.
11
ENGLISH
c) Press the MODE button to proceed to
memory location scanning (see below).
If you do not press any button within
10 seconds, the radio will automatically
resume scanning privacy codes.
To scan memory locations:
1. Press the MODE button until the Scan
icon, Memory Location icon and memory
location number flashes.
2. Push the CHANNEL SELECT button up or
down and the unit will begin scanning
memory locations.
3. The radio will continue to scan all memory
locations and stop if an incoming
transmission is detected. The unit will
remain on that location for 10 seconds.
During that time you can:
a) Press and hold the TALK button
and talk. The radio will remain on
that memory
location channel
TALK button
and return to
Standby mode.
ENGLISH
To scan memory locations (continued):
b) Push the CHANNEL SELECT button up or
down to resume scanning memory locations.
CHANNEL SELECT
button
c) Press the MODE button to proceed
to other functions.
If you do not press any button within
10 seconds, the radio will automatically
resume scanning memory locations.
(NOTE: If you want to reduce the number
of memory locations being scanned you
need to "unprogram" all unwanted locations
by changing both the main channel and
privacy code to 00. See Programming
Memory Locations, page 9.)
Using Call Tones
and VibrAlert ™
Your microTALK radio can alert you to
®
incoming signals by sounding an audible
call tone, by vibrating silently, or both.
To change ring settings:
O P E R AT I O N
1. Press the MODE button until the Ring
Setting icon flashes and the current
setting (Vibrate
+ Ring, Vibrate
Only, or Ring Only)
is displayed.
Vibrate + Ring
Vibrate Only
Ring Only
2. Push the CHANNEL SELECT button up or
down to change the ring setting.
3. Press and release the ENTER button to enter
the new setting, or press the MODE button
to enter the new setting and proceed to
other functions.
Stop Watch
You can use the timekeeping capability of your
microTALK ® radio as a stopwatch, including the
display of "split" times. To use the stop watch:
1. Press the MODE button until "Stop Watch"
and 00 :oo:oo are displayed in the LCD.
12