JETWAY P4845DDA User Manual page 30

OnChip IDE Channal0/Channel1
The integrated peripheral controller contains an IDE interface with support for two IDE
channels. Select Enabled to activate each channel separately. The settings are: Enabled and
Disabled.
Primary/Secondary Master/Slave PIO
The four IDE PIO (Programmed Input/Output) fields let you set a PIO mode (0-4) for each of
the four IDE devices that the onboard IDE interface supports. Modes 0 through 4 provide
successively increased performance. In Auto mode, the system automatically determines the
best mode for each device. The settings are: Auto, Mode 0, Mode 1, Mode 2, Mode 3, Mode
4.
Primary/Secondary Master/Slave UDMA
Ultra DMA/33 implementation is possible only if your IDE hard drive supports it and the
operating environment includes a DMA driver (Windows 95 OSR2 or a third-party IDE bus
master driver). If your hard drive and your system software both support Ultra DMA/33 and
Ultra DMA/66, select Auto to enable BIOS support. The settings are: Auto, Disabled.
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector read/write. If
your IDE hard drive supports block mode (most new drives do), select Enabled for automatic
detection of the optimal number of block read/writes per sector the drive can support. The
settings are: Enabled, Disabled.
3-7-2 Onboard Device Function
CMOS Setup Utility – Copyright(C) 1984-2002 Award Software
USB Controller
USB Keyboard Legacy Support
**Onboard AC97 Codec is xxxxxx **
AC97 Audio
AC97 Modem
Game Port Address
Midi Port Address
x Midi Port IRQ
↑ ↓ → ← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
AC97 Audio
This item allows you to decide to enable/disable the chipset family to support AC97 Audio.
The settings are: Enabled, Disabled.
Game Port Address/Midi Port Address
This will determine which Address the Game Port/Midi Port will use.
AC97 Modem
Onboard Device Function
Enabled
Disabled
Auto
Auto
201
330
10
F6:Optimized Defaults
28
Item Help
Menu Level >>
F1:General Help
F7:Standard Defaults