Table of Contents
Advertisement
This motherboard provides
sites for memory expansion available from minimum memory size of 64MB to maximum
memory size of 2.0GB DDR SDRAM.
Valid Memory Configurations
Bank
Bank 0, 1 (DDR1)
Bank 2, 3 (DDR2)
Total
NOTE!
Make sure the installed memory are DDR266 SDRAM support 133MHz
memory clock, otherwise the system may hang during startup.
Generally, installing DDR SDRAM modules to your motherboard is very easy, you can refer
to figure 2-4 to see what a 184-Pin DDR266/DDR200 DDR SDRAM module looks like.
NOTE!
When you install DIMM module fully into the DIMM socket the eject tab
should be locked into the DIMM module very firmly and fit into its
indention on both sides.
WARNING! For the DDR SDRAM CLOCK is set at 133MHz, use only DDR266-
compliant DDR Modules. When this motherboard operate at 133Mhz, most
system will not even boot if non-compliant modules are used because of the
strict timing issues, if your SDR Modules are not DDR266-compliant, set
the DDR SDRAM clock to 100MHz to ensure system stability.
2-5 Expansion Cards
WARNING!
Turn off your power when adding or removing expansion cards or other
system components. Failure to do so may cause severe damage to both
your motherboard and expansion cards.
2-5-1 Procedure For Expansion Card Installation
two
184-pin DUAL INLINE MEMORY MODULES (DIMM)
184-Pin DIMM
DDR200/DDR266
DDR SDRAM Module
DDR200/DDR266
DDR SDRAM Module
System Memory (Max. 2.0GB)
10
PCS
Total Memory
1
64MB∼1.0GB
1
64MB∼1.0GB
2
64MB∼2.0GB
Figure 2-4
Advertisement
Table of Contents
