Husqvarna 535RX Operator's Manual page 26

below the speed when the cutting attachment starts
to turn.
1. Turn the idle adjustment screw clockwise until the
cutting attachment starts to turn.
2. Turn the idle adjustment screw counterclockwise
until the cutting attachment stops.
Note:
Technical data on page 28 for the
See
recommended idle speed.
To sharpen the grass knife and grass
blade
WARNING:
protective gloves.
• To sharpen the grass knife or grass blade correctly,
refer to the instructions that come with the cutting
attachment.
• Sharpen all edges equally to keep the balance.
• Use a single-cut flat file.
WARNING:
that is damaged. Do not try to make a bent
or twisted blade straight and use it again.
To sharpen the saw blade
WARNING:
protective gloves.
• To sharpen the blade correctly, refer to the
instructions that come with the blade.
26
Stop the engine. Use
Always discard a blade
Stop the engine. Use
• Make sure that the product and blade has sufficient
support when you sharpen it.
• Use a 5.5 mm round file with a file holder.
• Hold the file at an angle of 15°.
• Sharpen one tooth of the saw blade to the right and
the next tooth to the left, see the illustration.
Note:
Sharpen the edges of the teeth with a flat
file if the blade is heavily worn. Continue to sharpen
with a round file.
• Sharpen all edges equally to keep the blade
balanced.
• Adjust the blade set to 1 mm with the recommended
setting tool. Refer to the instructions that come with
the blade.
15˚
1069 - 008 - 31.10.2022