Remote Control Battery Installation; Standby Mode - Jensen JBS-300 User Manual

NOTE ON NON-MAGNETICALLY SHIELDED SPEAKERS
This unit is not magnetically shielded and may cause color distortion on the screen of some TVs or
video monitors. To avoid this, you may need to move the unit further away from the TV or monitor
if unnatural color shifts or image distortion occurs.

REMOTE CONTROL BATTERY INSTALLATION

1.) Open the battery compartment cover.
2.) Insert two "AAA" (UM-4) batteries (not included) and
observe the polarity as indicated inside the battery
compartment when installing.
3.) Replace the cover.
Battery Precautions
 Replacement of batteries must be done by an adult.
Do not mix old and new batteries.

 Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
 If the batteries in the device have expired or the device is not to be used for a long period of
time, remove the battery to prevent damage or injury from possible battery leakage.
 The supply terminals are not to be short-circuited.
 Non-rechargeable batteries are not to be recharged.
 Exhausted batteries are to be removed.
 Only batteries of the equivalent type are to be used.
 Batteries are to be inserted with the correct polarity.
 Dispose of batteries properly. Do not dispose of batteries in fire or leave in direct sunlight.
The batteries may explode or leak.
 Clean the contacts of the batteries and the contacts in the device prior to battery installation.
Standby Mode is when the unit is first plugged into an AC power source (display flashes and
shows 12:00) or after all the settings have been made and the time is showing on the display.
Standby mode is also enabled when the
(Bluetooth/Radio/AUX) are off, no buttons are pressed and no alarms are sounding.
The LCD DISPLAY will flash 12:00 when the unit is plugged in for the first time. The unit is now in standby
mode.
Turning the unit ON:

In Off (standby) mode, press the
on the remote control to turn the unit ON. The last selected source icon will show on LCD
DISPLAY.
Turning the unit OFF:

To turn the unit OFF (standby mode), press the
main unit or on the remote control to turn the unit OFF. The LCD DISPLAY will dim and show
the current time.

STANDBY MODE

Button is pressed and all functions
TURNING THE UNIT POWER ON/OFF
POWER/ STANDBY BUTTON on top of the main unit or
POWER/ STANDBY BUTTON on top of the
E-10