Entering Setup; Selecting The First Boot Device - MSI Hetis 915 User Manual

Chapter 4
Power on the computer and the system will start POST (Power On Self Test)
process. W hen the message below appears on the screen, press <DEL> key
to enter Setup.
DEL: Setup Menu
If the message disappears before you respond and you still wish to enter
Setup, restart the system by turning it OFF and On or pressing the RESET
button. You may also restart the system by simultaneously pressing <Ctrl>,
<Alt>, and <Delete> keys.

Selecting the First Boot Device

You are allowed to select the 1st boot device without entering the BIOS setup
utility by pressing <F11>. When the same message as listed above appears on
the screen, press <F11> to trigger the boot menu.
The POST messages might pass by too quickly for you to respond in time. If so,
restart the system and press <F11> after around 2 or 3 seconds to activate the
boot menu similar to the following.
IDE-0
CDROM
[Up/Dn] Select
The boot menu will list all the bootable devices. Select the one you want to boot
from by using arrow keys and then pressing <Enter>. The system will boot
from the selected device. The selection will not make changes to the settings
in the BIOS setup utility, so next time when you power on the system, it will still
use the original first boot device to boot up.

Entering Setup

TAB: Logo
Select First Boot Device
: IBM-DTLA-307038
: ATAPI CD-ROM DRIVE 40X M
[RETURN] Boot
4-2
F11: Boot Menu
[ESC] cancel
F10: Flash Recovery