Safety Information - Fluke 189II/AN Service Manual

Safety Information

The Meter complies with:
•
ANSI/ISA 82.02.01 (61010-1) 2004
•
UL 61010-1:2004
•
CAN/CSA-C22.2 No. 61010-1-04
•
IEC/EN 61010-1 2
•
EMC EN 61326-1
•
Measurement Category III, 1000V, Pollution Degree 2
•
Measurement Category IV, 600 V, Pollution Degree 2
In this manual, a Warning identifies hazardous conditions and actions that could cause
bodily harm or death. A Caution identifies conditions and actions that could damage the
Meter, the equipment under test, or cause permanent loss of data.
To avoid possible electric shock or personal injury, follow these
guidelines:
•
Use this Meter only as specified in this manual or the
protection provided by the Meter might be impaired.
•
Do not use the Meter if it is damaged. Before you use the
Meter, inspect the case. Look for cracks or missing plastic.
Pay particular attention to the insulation surrounding the
connectors.
•
Make sure the battery door is closed and latched before
operating the Meter.
•
Remove test leads from the Meter before opening the
battery door.
•
Inspect the test leads for damaged insulation or exposed
metal. Check the test leads for continuity. Replace damaged
test leads before using the Meter.
•
Do not apply more than the rated voltage, as marked on the
Meter, between the terminals or between any terminal and
earth ground.
•
Never operate the Meter with the cover removed or the case
open.
•
Use caution when working with voltages above 30 V ac rms,
42 V ac peak, or 60 V dc. These voltages pose a shock
hazard.
•
Use only the replacement fuses specified by the manual.
•
Use the proper terminals, function, and range for
measurements.
•
Avoid working alone.
nd
Edition Pollution Degree 2
XWWarning
True-rms Digital Multimeter
Safety Information
3