Table of Contents
Advertisement
R-net Omni2 bluetooth set-up & operation user guide
1 Pairing with a Bluetooth device
The Omni2 must first be put into Discovery Mode via the sequence below.
Enter Bluetooth Mode and select the device you wish to pair with
Deflect the SID in the forward direction and hold until there is a beep. This will take approximately 10
seconds, then release
Deflect the SID in the reverse direction and hold until there is a beep. This will take approximately 10
seconds, then release.
A screen such as below will appear – the flashing blue icon confirming the Omni2 is in Discovery Mode.
Depending on which type of device is being paired with – a Windows PC, an Android device or an iDevice –
refer to one of the following three sections.
1.1
Pairing with a Windows PC
If the PC does not have integrated Bluetooth, then a receiver Dongle must be used and its drivers installed.
Curtiss-Wright recommends use of the following Bluetooth Dongles:
Trust BT-2400
Linksys USBBT100-UK
Belkin F8T012uk1 Version 1000
3
7337A R-NET OMNI2 Set-up & Operation User Guide
magicmobility.com.au
Advertisement
Table of Contents
