Lowrance iWAY 600C Quick Start Manual page 5

To attach the flexible suction cup mount to the back of the GPS unit
align the mount with the back of the unit. Place the base of the flexible
suction cup mount against the back of the unit by matching the male
and female connector ends together.
Then snap the mount into place by sliding the flexible suction cup
mount up. Pull down on the flexible suction cup mount to disengage it
from the back of the unit.
The mounting surface should be free of dirt and oil. Press the suction
cup against the mounting surface and, while maintaining pressure,
push the locking lever down until the arm is secure.
NOTE:
Some areas restrict mounting any electronic device to a dash or
windshield. Be sure to check your local laws before using any elec-
tronic mounting device.
If the suction cup has problems staying secured to the mounting sur-
face, clean the mounting surface and the suction cup with alcohol then
reinstall. Moistening the suction cup may help it stick in some cases.
To remove the suction cup base, disengage the locking lever and pull on
the suction release tab to break the vacuum seal.
Adhesive Mounting Plate
In some automobiles a typical windshield mount may be difficult or un-
desirable. The flat self-adhesive mounting plate allows you to mount
the unit somewhere else, such as on the dashboard or center console.
Attaching the unit to mounting arm.
Align the suction cup mount with the
back of the unit and snap it into place
by sliding the mounting arm up.
4