Summary of Contents for SECO-LARM E-941D 600Q Series
Page 1
Double-Door Electromagnetic Locks Installation Manual E-941DA-1K2Q shown Model Holding Force Material † E-941Dx-600Q 600-lb. (272kg) x2 Anodized aluminum E-941Dx-1K2Q 1200-lb. (545kg) x2 Anodized aluminum E-941Dx-600PQ 600-lb. (272kg) x2 Anodized aluminum ‡ E-941Dx-1K2P 1200-lb. (545kg) x2 Anodized aluminum ‡ "x" is the variable for product color "A" for aluminum, "B" for black, and "D" for dark bronze †...
3. The most suitable mounting location for the electromagnetic locks may require the use of additional SECO-LARM accessories such as Z-brackets, L-brackets, and/or spacer plates. 4. Do not run power wires and signal wires in the same conduit as this may cause interference.
SECO-LARM Double-Door Electromagnetic Locks Installation Fold the mounting template along the dotted Close the doors. Find a mounting location on the line to form a 90-degree angle. center of the door frame, directly above where both doors meet when closed.
Page 5
SECO-LARM Double-Door Electromagnetic Locks 7. Put a rubber washer between the two metal 8. Tighten the armature screws enough so that washers and place them over the armature the armature plates can withstand a break-in screw between the armature plates and the attempt, but loose enough so that the armature doors.
Page 6
SECO-LARM Double-Door Electromagnetic Locks 13. Push the electromagnet against the mounting plate so 12. Remove the cover from the front of the the ends are flush with each other. Use the Hex electromagnets. Run the power leads wrench to screw the hex-head mounting screws through the large cable access holes.
SECO-LARM Double-Door Electromagnetic Locks Wiring Diagram Circuit Board Control Device – N.O. – N.C. Power Supply 12/24 VDC Voltage = 12VDC jumpers = 24VDC NOTES Connect switching devices like push-to-exit switches between the power source and the positive terminal of the lock. Connecting them to the negative terminal may cause a delay in unlocking.
IMPORTANT: Users and installers of this product are responsible for ensuring that the installation and configuration of this product complies with all national, state, and local laws and codes. SECO-LARM will not be held responsible for the use of this product in violation of any current laws or codes.
This manual is also suitable for:
E-941d 1k2q seriesE-941d 600pq seriesE-941d 1k2p seriesE-941da-1k2qE-941db-600pqE-941db-1k2p...
Show all