About This Documentation; Overview On Target Groups And Product Phases; Purpose; Scope - Bosch Rexroth IndraControl VAC 01 Operating Instructions Manual

Y-repeater
Table of Contents

Advertisement

DOK-SUPPL*-VAC*01*****-IT04-EN-P
IndraControlVAC 01 Y-Repeater
1

About this documentation

1.1

Overview on target groups and product phases

1.2

Purpose

1.3

Scope

In the following illustration, the framed activities, product phases and target
groups refer to the present documentation.
Example:
In the product phase "Mounting (assembly/installation)", the "mechanic/elec‐
trician" can execute the activity "install" using this documentation.
Mounting
Product
Selection
phases
(assembly/installation)
Presales Aftersales
Design engineer
Mechanic/
electrician
Programmer
Technologist
Target
Process
groups
specialist
Select
Unpack
Prepare
Activities
Design
Construct
Fig. 1-1:
Assigning the present documentation to the target groups, product
phases and activities of the target group
This document instructs the technical staff of the machine manufacturer on
how to perform the mechanical and electrical installation safely and on how to
commission the device.
Required qualifications: Individual who is able to assess the tasks assigned
and identify possible safety risks owing to qualification in the subject, knowl‐
edge and experience. The individual should also be familiar with the stand‐
ards and regulations.
This document is valid for
Y-repeater (type designation code VAC01.1S-YD1-NNNN)
Y-repeater with additional digital input to enable the "Energy Save
Mode" at the passive operator display (type designation code
VAC01.1S-YD1-TCES)
The type code specifications are located on the type plate of the device (also
refer to
chapter 2.1
"Product identification" on page 7
"Ordering information" on page
Bosch Rexroth AG
Engineering
Commissioning
Programmer
Commissioning engineer
Technologist
Process specialist
Parameterize
Optimize
Mount
Program
Test
Install
Configure
Simulate
43).
3/53
About this documentation
Operation
Decommissioning
Machine
operator
Maintenance
Mechanic/
technician
electrician
Service
Disposal company
Operate
Dismount
Maintain
Dispose
Remove
faults
Create
the NC program
and
chapter 15

Advertisement

Table of Contents
loading

Table of Contents