DOK-SUPPL*-VAC*01*****-IT04-EN-P
IndraControlVAC 01 Y-Repeater
13
Error causes and troubleshooting
Device states are indicated at the front panel via LED.
The arrangement of the LED on the front panel is shown in
could not be
resolved.].
Errors
LED Vin at the Y-repeater is not
on
The active operator display can‐
not be operated
No image is displayed at the ac‐
tive operator display
The active operator display can‐
not be operated. No image is
displayed and the Vin LED is on
at the control cabinet PC
①
Only the Y-repeater VAC01.1S-YD1-TCES
Tab. 13-1:
Error causes and troubleshooting
Repairs at the device by the customer are not permitted. Excep‐
tions are maintenance works listed in the chapter "Maintenance".
For further information in the event of repair, please contact the
Bosch Rexroth Service.
Bosch Rexroth AG
Error causes and troubleshooting
Troubleshooting
●
Plug not connected to X1S1 or X1S2
●
External voltage supply does not supply
voltage
●
Check whether all cables are plugged on at
the CDI interfaces (control cabinet PC, oper‐
ator display and Y-repeater)
●
Check for the plugs X1S1 or X1S2 at the in‐
put SEL
●
Check for the plug X1S2 at the input ESM
●
Check whether all cables are plugged on at
the CDI interfaces (control cabinet PC, oper‐
ator display and Y-repeater)
●
Check for the plugs X1S1 or X1S2 at the in‐
put SEL
●
Check for the plug X1S2 at the input ESM
●
XSER cable and XVID cable to the Y-re‐
peater are interchanged
39/53
[External link
①
①
①