Parameters - Mitsubishi Electric NZ2GF-ETB User Manual

10.3

Parameters

This section describes the parameters of the Ethernet Adapter Module. The setting dialog box can be displayed by the
following operation.
Setting item tree  NZ2GF-ETB  [Parameter]
The Parameter Setting dialog box contains the following three kinds of settings, and each of them can be displayed by
selecting the tab.
Item
For the Ethernet Adapter Module, specify whether or not to:
System
• Allow remote reset.
• Hold error logs when the system is powered off or reset.
CC-Link IE Field Configure the settings for connecting the Ethernet Adapter
Network Module to CC-Link IE Field Network.
Configure the settings for connecting the Ethernet Adapter
Ethernet
Module to Ethernet.
*1 The parameter numbers are used to identify an invalid parameter when a parameter error has occurred.
(1) Buttons
The buttons displayed in the Parameter Setting dialog box are explained below.
Button
[Default] button
[Check] button
[End] button
[Cancel] button
188
Description
Sets default values for all of the setting items on the current dialog box.
Checks if the parameters set on the current dialog box are correct.
Ends the setting.
Cancels the setting.
*1
Parameter No.
1002 , 01F0
H H
01F0
H
9181
H
Description
Reference
Page 189, Section
10.3.1
Page 190, Section
10.3.2
Page 193, Section
10.3.3