Table of Contents
Advertisement
5.1 Types of data
5.1.1 Parameters and data required for control
The parameters and data required to carry out control with the Simple Motion module
include the "setting data", "monitor data" and "control data" shown below.
Setting data
The data is set beforehand according to the machine and application. Set the data
with programs or GX Works2. The data set for the buffer memory can also be
saved in the flash ROM or internal memory (nonvolatile) in the Simple Motion
module.
Important
The setting data can be backed up only in the flash ROM/internal memory (nonvolatile) of
the Simple Motion module. It cannot be backed up in the PLC CPU and the SD memory
card mounted to the PLC CPU.
The setting data is classified as follows.
Chapter 5 Data Used for Positioning Control
5 - 2
Advertisement
Table of Contents
