Multi Radio Control; Selecting Radios; Oem Control Head - Motorola TETRA MTM5000 Series User Manual

1 A visor microphone.
2 A microphone of the device that is off hook.
3 A microphone that was last in use (if two devices are off hook).
If an accessory is connected through the junction box, the active microphone depends on the
hook state of the accessory:
• If the accessory is on the hook, the visor microphone is active.
• If the accessory is off the hook, the microphone of the accessory connected to the telco
connector is active.
2 To end the call, press the End key.
NOTE: If you hang a fist microphone or telephone style handset into the clip or holder,
the call ends or the audio switches to a connected speaker. This call behavior depends
on the configuration of your service provider.
5.10

Multi Radio Control

NOTE: This is a Software Selling Feature.
This feature allows the user to control two radios from a Control Head. The user can monitor one task
force and communicate with another task force simultaneously.
Radio 1 is the primary radio and Radio 2 is the secondary radio. Radio 1 and Radio 2 are connected
to each other, with Radio 1 directly connected to the control head.
5.10.1

Selecting Radios

The control head only controls one radio at a time.
When and where to use: Press the One-Touch Button to select the next available radio or perform the
following steps to select a radio via the menu.
Procedure:
1 From the home screen, press the Menu key.
2 Select Radio Selection.
3 Select one of the following options:
• Radio 1
• Radio 2
The Radio Selection Tone sounds when a radio is selected from the one-touch button or the Radio
Selection menu.
NOTE: Check with your service provider to enable the Radio Selection Tone feature.
5.11

OEM Control Head

NOTE: This is a Software Selling Feature.
68015000180-MR
Chapter 5 : Features
133