THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
For Printed Wiring Boards.
Note:
• X : Parts extracted from the component side.
• Y : Parts extracted from the conductor side.
•
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side:
Parts on the pattern face side seen
(Conductor Side)
from the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Component Side)
the parts face are indicated.
Caution:
Pattern face side:
Parts on the pattern face side seen
(SIDE B)
from the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(SIDE A)
the parts face are indicated.
• DMB19 board is multi-layer printed board. However, the
patterns of intermediate-layers have not been included in
this diagrams.
• Indication of transistor.
C
Q
These are omitted.
B
E
Q
B
C E
These are omitted.
• Abbreviation
AR
: Argentina model
BR
: Brazilian model
E2
: 120V AC area in E model
E51
: Chilean and Peruvian models
MX
: Mexican model
HCD-PZ1D
For Schematic Diagrams.
Note:
• All capacitors are in μF unless otherwise noted. (p: pF) 50
WV or less are not indicated except for electrolytics and
tantalums.
• All resistors are in Ω and 1/4 W or less unless otherwise
specifi ed.
• 2 : Nonfl ammable resistor.
• 5 : Fusible resistor.
• C : Panel designation.
Note: The components identifi ed by mark 0 or dotted
line with mark 0 are critical for safety.
Replace only with part number specifi ed.
• A : B+ Line.
• B : B– Line.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
no mark : FM
*
: Impossible to measure
• Voltages are taken with VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal production
tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal production
tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F
: AUDIO
f
: TUNER
: VIDEO
L
g : COMPONENT VIDEO
J
: DVD (AUDIO)
: DVD (RF)
c
I : DVD (DIGITAL)
N
: USB
• Abbreviation
AR
: Argentina model
BR
: Brazilian model
E2
: 120V AC area in E model
E51
: Chilean and Peruvian models
MX
: Mexican model
• Circuit Boards Location
TRANSFORMER board
LCD CTRL board
FRONT board
SW board
MOTOR (LD) board
CENTER board
LEFT board
VOL-LED board
USB-LED board
39
39
TRANS-SUB board
VIDEO board
SENSOR board
MOTOR (TB) board
DRIVER board
DMB19 board
TOP-KEY board
PS-DET board
AMP board
JUNC board
MAIN board
RIGHT board
MIC board
HCD-PZ1D
Ver. 1.1