Bu Holder Block - Sony HCD-PZ1D Service Manual

HCD-PZ1D

2-19. BU HOLDER BLOCK

N
Perform work with this wire (flat type) (24 core) connected, or make a bridge as mentioned above and then disconnect
the wire (flat type) (24 core). (Optical pick-up will be destroyed without bridging.)
On the contrary at the installation, connect the wire (flat type) (24 core) first, and then remove the bridge.
Note 1: For a soldering iron, use the one with a ground wire. (Refer to DISASSEMBLY 2-19. DMB19 BOARD)
1 connector
(CN1105)
– Bottom side view –
Note 5: When you install the BU holder
block, hang the holder (310) assy
on the lever (lifter (H)).
20
N NG
7 connector
(CN201)
5 connector
6 wire (flat type)
(7 core)
(CN4602)
2 connector
3 flexible flat cable (7 core)
(CN1104)
4 wire (flat type) (9 core)
(CN1106)
qf cam shaft
qg BU holder block
Note 4: When you disassemble the BU holder block,
confirm the holder (310) assy is a normal
position.
lever (lifter (H))
i e setti
(CN601)
Tape
(CN1103)
Tape
Note 2: Process the wire
Note 3: When you install the flat cable, please
install them correctly.
There is a possibility that this machine
damages when not correctly installing it.
OK
Insert is straight
to the interior.
flexible
cable
qs floating screw
(PTPWH M2.6)
connector
qd shaft
0
holder (310) assy lever (lifter (H))
OK
Tape
Tape
Tape
NG
straight so as not
to touch on the
connector.
CN101
NG
Insert is incline
flexible
cable
connector
qa dust cover (BU)
8 two screws
(BVTP 3
9 screw
(BVTP 2.6 (3CR))
holder (310) assy
NG
8)