Shutdown (No-Cleaning Stop) - Hitachi UX2 Instruction Manual

Chapter 1. Overview

1.2.4. Shutdown (No-cleaning Stop)

When you press Shutdown
its automatic nozzle cleaning sequence. If you repeatedly press Shutdown to stop the operation, excessive
makeup will enter the unit, resulting in thinner ink or an exceeded solution level of the ink main tank. If it is
necessary to repeatedly stop the unit operation, use the following procedure. (For details on the [HOME] screen,
see "5.1. HOME Screen (Initial Screen)".)
The no-cleaning stop procedure is valid even while the startup sequence is being executed.
( Shutdown is inactive during the startup sequence.)
[Note]
・ You can use Shutdown to stop operation up to twice in a row.
・ When operation is stopped using No-cleaning stop, if it is left in that state, the ink will become stuck in
the nozzle and cause ink stream bending, nozzle clogging, or printing disturbance. Apply makeup to the
nozzle orifice and wash it within 30 minutes after the stop. Then, eject the ink again.
1
Press Shutdown at the bottom right of the [HOME] screen.
1-6
 OK at the bottom right of the [HOME] screen, the unit stops after completing
Operation shutdown instruction screen
Press Shutdown.