Rotating Operation - Echo Shindaiwa DH232 Operator's Manual

OPERATION
2. Stop Switch
Move stop switch (A) to STOP
position.
If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall engine.
Have your dealer repair stop switch before using unit again.

Rotating Operation

This model is equipped with a
rotating throttle handle that can be
turned 90° to either side of vertical
operating position to help reduce
operator fatigue and improve
precision trimming.
Always stop the engine before rotating the handle!
Failure to do so could result in serious injury.
To operate
1. Fully release throttle trigger.
2. Push handle release lever.
3. Rotate the handle 90° in the
desired direction and release
the lever. Make sure that the
handle is fully locked into
position before use.
Note: The throttle trigger will not
operate when the throttle
handle is not fully locked
into position.
24
DH232
A
X7712240202
© 07/22 ECHO Incorporated