Attaching Bi-Admin To A Remote Wireless Printserver; Resetting The Wireless Printserver; Restoring Factory Default - Linksys WPS11 User Manual

Attaching Bi-Admin to a Remote Wireless PrintServer

The Bi-Admin program can locate Wireless PrintServers on networks other
than your own, given your network is running TCP/IP across a WAN or other
network-to-network link via a router. To attach Bi-Admin to a remote Wireless
PrintServer located on a remote network, click on Init Device, then Attach.
The Add Cross Segment PrintServer window will appear. Enter the IP
address of the remote unit, then click Set. The remote Wireless PrintServer will
appear in the list of available PrintServers, allowing you to configure it.

Resetting the Wireless PrintServer

If the Wireless PrintServer seems locked up for any reason, you can reset it
from the Bi-Admin program. To reset a Wireless PrintServer, click once on the
Device Name of the Wireless PrintServer you want to reset, followed by Init
Device, then Reset Device. You can also reset it by pressing the Reset button
on the back of the unit, or by unplugging its power cord.

Restoring Factory Default

If you have made irreversible changes in configuration that have rendered the
Wireless PrintServer unusable, or if you simply want to start over from scratch,
you can set the Wireless PrintServer back to the default mode so that the device
will operate just as it did when you purchased it. Click on Init Device, then
Restore Factory Default.
C C a a u u t t i i o o n n ! ! Restoring Factory Default will e e r r a a s s e e A A L L L L of the work that
you have done on this unit since purchasing it.
19
Instant Wireless™ Series
Wireless PrintServer
Logical Port Configuration:
Logical Port Configuration Icon
To set or change the Wireless PrintServer's logical port set-
tings, highlight the Wireless PrintServer to be changed and
click on the Logical Port icon (shown here). The Logical
Port Configuration window will appear. Make any
changes to the settings, and click on Save to Device when
you are finished.
Upgrading the Firmware:
The Firmware Upgrade Icon
To make sure that the Wireless PrintServer is running its
most current version of firmware, upgrade the device's
ROM chip regularly. To do so, you must be able to access
the Wireless PrintServer device from your computer. Click
on the Upgrade Firmware icon and follow the instructions
on the screen.
Exiting Bi-Admin:
To exit the Bi-Admin program, just click on the Exit icon.
Configuring Wireless:
To configure the wireless settings, just click on the
Wireless icon.
The Application Exit Icon
The Wireless Icon
20