Linksys EFSP42 User Manual page 11

The window below will appear as the files are copied to your computer.
6. Before the file copy finishes, the Configure PrintServer window will
pop up again as a pre-test. Click Cancel to complete the file copy. To
check for your successful file copy, click on Start, Programs, Linksys
PrintServer Driver, and check to see that TCPIP Setup is on its sub-
folder.
If you are setting up the network administrator's computer, finish steps 7 to
10. Otherwise, if you are simply installing this on a network user's computer,
skip steps 7 to 9 and proceed to step 10 to finish this section.
16
Instant EtherFast ® Series EtherFast 10/100 PrintServers
7. On the network administrator computer only, click Start, Programs,
Linksys PrintServer Driver, and TCPIP Setup to set up your
PrintServer's IP address.
8. In the Device Name field, enter the PrintServer's 8-digit Default Name
written on page 10 and the white barcode sticker on your unit. The exam-
ple settings below for the PrintServer Settings and the Network
Administrator Computer Settings show how the settings have been set for
the picture in step 7. If you are not sure what settings to use, see your
network administrator.
Printserver Settings
Device Name: SCA71107
IP Address: 10.0.0.2
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0 (optional)
Network Administrator Computer Settings
IP address: 10.0.0.1
Subnet Mask: 255.255.255.0
9. When you are finished entering the values for the IP address, Gateway
address (optional), and the Subnet Mask, click Set Device.
10. If you are configuring a...
• Windows 98/95 computer, go to page 18 to finish your PrintServer Setup.
• Windows NT 4.0 computer, go to page 23 to finish your PrintServer Setup.
17